V-Gravieren
Das Prinzip dieser Bearbeitung istzwischen zwei Linien zu schneiden die eine Begrenzung bilden. Ein V-Nut Fräser taucht dabei so weit ins Material ein wie die Breite zwischen denGrenzen es zulässt. Je breiter der Abstand zwischen den Begrenzungslinien ist um so tiefer taucht der V-Nut Fräser ein.
Dieses Plugin bietet zur Zeit keine Unterstützung für mehrere Zustellungenb, Sie sollten daher vorsichtig sein. Für den Fall das die Fräsung nicht in einer Zustellung gefräst werden kann begrenzen Sie die Frästiefe mit "Maximale Tiefe" und wenden mehrere Mop mit unterschiedlichen Tiefen an. Man verwendet für jede Tiefenzustellung eine Mop.


Zur Anwendung wählt man geschlossene Pfade oder Texte aus und ruft die V-Gravieren Bearbeitung über das Bearbeitungsmenü auf.
Die Zeichnung in Cambam
Then complete the properties of the machining operation.
The array below only lists the properties specific to this operation
Properties
Tool |
|
Tool V-Angle | Angle of the V-cutter Note: For this operation, the tool must be a V-Cutter ; The build-in Tool Profile property of CamBam is ignored by the plugin. |
Tool Diameter |
Tool diameter (in drawing units) Maximum diameter of the top of the V of the cutter. This value will allow the plugin to calculate a maximum machining depth so as not to go lower than allowed by the V of the cutter. This value is used to do calculations if Max Depth is set to Auto |
Tool Tip Diameter | If the cutter has a flat end, this diameter corresponds to the diameter of the tip. |
Cutting Depth |
|
Max Depth |
Limits the maximum depth of machining. This value is a positive value representing the maximum depth to be reached. If this parameter is set to Auto, the maximum depth is automatically calculated so that the cutter does not go down lower than allowed by the V. (using the diameter value of the tool for calculations) |
Stock Surface | The Z starting point for the cut. The plugin works as the Profile/Pocket operations, the Z position of the drawing is unimportant; the cut starts from Stock Surface. |
Options |
|
Max Corner Angle |
Maximum angle for the corners where a ascent of the tool will be added . If the angle and larger than this value, no ascent of the tool will be generated. |
Path Step Size |
Length of the steps in the toolpath. For work in mm, a value of 0.1 gives a correct resolution with a reasonable calculation time. |
Mehrere Ansichten der Simulation in CutViewer,Es wurden zwei V-Gravieren Bearbeitungen benutzt. Die erste wurde mit einem 90° V-Nut Fräser angelegt für alle Objekte die in Weiß zu sehen sind, die zweite wurde mit einem 60° Fräser angelegt für alle Objekte in Blau in der Zeichnung oben.

Informationen
Creator |
pstemari, llyodsp, Eddycurrent, dh42 |
Last version / Date |
V 0011 - 15 December 2016 V 1.2.0.1 - 30 August 2018 |
Download plugin | |
Documentation | |
Requirements | CamBam 0.9.8 P, V1.0, Linux version |
Forum Link | V-Engrave plugin on the forum |